Frage von Paul*Berlin:
I'll do it now but once a separate thread on ...
Post --- 1 --- We just opened up for live Internet streaming an Edirol V8. It offers many advantages over the Datavideo SE500, the synonymous still fit in our budget, but the great disadvantage that it has no Tally-out. The advantages are outweighed, however, no preference.
For some projects, but I would love a tally right. One could buy for 1000 ¬ ¬ a device for MIDI, but that then acts as Tally-Centrale (; or someone put forward a series switch, the red lights and one-off ^ ^). Would be too expensive (; or too boring and insecure). I have at Thomann found this MIDI controller, you can teach him now that eg (; engine) goes to the top of a fader, if channel 1 is on Bus A and Bus A is active? (; I'm pretty sure that this information is transmitted via MIDI, because in this way and, yes can control audio mixers)
If so, could you attach s.jedem fader a contact that closes a circuit with a red light camera s.der when the fader is at the top ... Is a bit of craft work and may seem synonymous funny, is not (but very) expensive and reliable for ...
--- Answer --- SRone the first would be interesting to know who gives out Edirol midi?
on that basis, would be a midi-to-switch converter interesting that closes an incoming contact, depending on the MIDI signal, therefore, would be the behringer bastelarbeit obsolete.
s.den then switch output a voltage source and a pear and you tally.
in the manual of the Edirol would have to find one site called midi-implementation, they work side with the midi-implementation side of the Syndicate midi-to-switch converters, where it has the functionalities match it would have to synonymous exist if questionable invite but sometimes the midi -implementation of the Edirol somewhere high, then I throw a look a look.
Post 2 --- my --- can you give me a link to send a midi-to-switch or call at least one price? and then it is only a necessary, or for any tally that you wish to own one?
Edirol MIDI is the case of any (; just as he receives), because you can indeed synonymous V-Link compatible (; Roland synchronize) equipment over it. I have here the link to the manual of the mixer, but look synonymous himself look:
http://www.edirol.com/images/stories/products/v8/v8_manual.pdf
Antwort von srone:
Read the instructions to say after a short Edirol, works as intended, which sends each Edirol s.ihm homemade feel pressure (eg channel selection) a midi message, so far so well. there is this switch to midi converter in various sizes of 4-128kanal, of doepfer eg, ees, etc. prices to size regulation.
eg here
Antwort von Paul*Berlin:
so, after a long (relatively to the internet for such things) look for a price I've now used an offer, found on ebay and have noticed surprised that the price so only slightly higher than 100E. if you can tell me what outputs for the device has, and what would ranpassen as good then I would buy a big step to come closer (I'm just a glance in the manual of the ees mcs8 thrown, but the second page the anl at which this should be listed, can my adobe reader not show. why always synonymous)
many greetings
Antwort von srone:
If you enter email, I send you the pdf, or try it via right click "save as".
lg
SRone
Antwort von Paul*Berlin:
if the pdf is displayed correctly with you, then you can send me a screenshot of page 2, as my reader says that the document is not supported (, or something like that).
I thank you again very much for your support and active aid advice!
many greetings, paul!
Antwort von srone:
mail is out.
lg
SRone
Antwort von Paul*Berlin:
Okay, thank you so much, now can even open the pdf document, I do not synonymous, what with what I downloaded I was different ... A very short (last) question: The tension that comes out of there is, indeed probably not be large. But is that to a small bulbs or LED, so the need between 1.5 and 3.5 V and 20 mA and 200 ...? I hope so;)
PS: Cool logo! ;)
Antwort von thos-berlin:
For my understanding goes a mere implementation of a button - Tally light is not enough.
The Edirol V8 has two buses (A & B), between which Usper T-bar switches can be mixed /. The mere touch of a button so s.Bus enough for Tally is not enough. It remains to be evaluated which of the two coaches is just on-air. So a small electronics behind it? ...
Or delivers the Edirol as a "finished" signal within the meaning of Ch1 On Air, Channel 2 is no longer on air ...
Antwort von Markus_Krippner:
Another approach:
Everyone gets a cameraman, one additional (small, cheap) monitor, which constantly shows the master out of the V8. Then he sees synonymous when it is "on air".
Yet another approach:
The cameraman will be notified by intercom that he's grad on the air.
Markus ... :-)
Antwort von srone:
A very short (last) question: The tension that comes out of there is, indeed probably not be large. But is that to a small bulbs or LED, so the need between 1.5 and 3.5 V and 20 mA and 200 ...? I hope so;) there is no voltage out, since only one relay is closed
(midi-to-switch), a power supply for the leds you need to establish themselves naturally.
PS: Cool logo! ;) Thanks :-)
@ Thos-berlin
the next top Linked midi-to-switch converter takes over the task of elekronikkästchens required of you and provides 8 switched outputs.
lg
SRone
Antwort von Paul*Berlin:
@ SRone: good, thank you, I would think with a bit of the notice synonymous, but may well ... I have to see if I now buy the device itself, let or buy, we'll see.
@ Markus: the approaches I have already thought through synonymous, but in the monitors you have more expensive and more expensive cable routes signals (the monitors). Also you can not then simply pay for each camera a "tally" because it costs for each yes (for cameras right next to the director you think then that it was unnecessary or unmanned cameras ... another approach, which very similar is, is that you need a big TV (or projector with canvas) for all sets up camera men visible, leaves, unfortunately, because the studio is not suitable for it.
thoughts with the intercom, I had been synonymous, but since you would need then would be synonymous again for someone who does this, and the cable paths again more expensive (with a larger budget certainly synonymous a good, probably even better solution!)
@ Myth: as I said, I certainly am not, so I now synonymous either the V8 or a MIDI device there, so I can try it, aer I am very sure that, in the Midi-synonymous signal between A and B is distinguished (please excuse my non-technical
formulations;)), and even if not, it would be synonymous not bad if tally synonymous with the other bus on the selected camera the lights.
think with many thanks again for your help and all!
Antwort von srone:
:) [/ B]), and even if not, it would be synonymous not bad if tally synonymous with the other bus on the selected camera, the lights. according to thy will Edirol midi-implementation distinction as well.
lg
SRone
Antwort von Paul*Berlin:
according to thy will Edirol midi-implementation distinction as well. you are here is clearly the expert, I (still) not.
I find better, however, that there is a distinction.
now is, only buy some time yet again and then report whether it works with the V8 really;)
Antwort von srone:
If you have problems or even ask, you've got now my email ;-)
lg
SRone
