|  |  | |
| Show current time code can
Question of Buxx:
Mai 2007
Hello!
I cut with Premiere Pro 2 and have a concert several hours with two cameras recorded.
One Camera is the main camera and it ran continuously.
Now I would like between the cameras out and herschneiden, however, ran the 2nd Camera is always with many, many interruptions.
Now I am looking for a setting (if it exists) at first, that my current time code of the second camera is displayed. It is not professional, so does the Timcecode always at 0. Nevertheless, I would very much work-saving, because then I could always recognize when a cut has taken place (ie the camera was just out)
Unfortunately I found this setting anywhere. But as synonymous Premiere batch capture can have it but the end-dv files with a time code (to stop every few minutes starts again at 0) which have.
I would be very pleased to receive an answer
Greeting
Bastian
Reply Buxx:
high again with the thread.
will not spam, but an answer today would be very helpful to me. Thank you
Reply robbie:
I commend you for capturing the Szenealizer use. This reads the time from the tape and writes them out as the filename. This works, however, synonymous only good if the two cameras on an equal time had set. Otherwise you use the synonymous for your project is not.
Schöne Grüße,
Robbie
Reply RainerE:
thank you, but that brings me nothing more, because the files I've already captured.
'm now in the cut and looking for the setting (if it exists) that I premiere the original time code display. (if it works!)
Reply RainerE:
is not .. sorry
Reply RainerE:
premiere is really not the current time code show?
dv but must synonymous but have a time code. I can finally synonymous premiere pro capture or re-cut it offline?
Reply robbie:
I do not know what you think with the Orignial - Timecode mean.
The camera takes the? The should be quite normal with eh displayed. At least if you are the project window with all the clips and you vergrößerst times anschaust all columns that are there, then surely you can find some time codes ... because he is not there?
Otherwise, for the next concert / play a small tip: Both cameras can go through!
Beautiful evening
Robbie
Reply Buk:
the camera was kapputt. always went out - so the fummelei.
but is synonymous gone.
can be avid for the current time code (synonymous to the original time code of the camera, yes!) can always show.
at premiere apparently not.
I just do not know whether the s.dv lies or s.premiere itself
again:
if I record the whole band as a file, there are many different scenes file. every time the camera was made, the time code starts again from scratch.
I see in the cut but not when the time code, the übersprünglich on the band was to change.
| |
| |
