Frage von Lena:
Hello s.alle the likes Avidrätselraten:
Yesterday we wanted a few tapes and capturn are a few problems occurred ...
To our Prod environment: We have 3 Avidschittplätze, which are set all equal. Avid, Mojo, various Mazen, reference monitor
Morning, there was no trouble Capturn, early afternoon was the line everything is OK, the evening just before closing time, there was the following problem:
The Maz takes the tape, and plays it from synonymous, the reference monitor shows the Picture, I can capture the tool to control the Maz, but I get no picture on my screen ...
In addition, a few seconds after I press Rec to an error message: Error undefinable (ie Avid knows it apparently does not exactly ...)
All connectors are sitting.
Same problem occurs when:
Replacing all the cable between the Mac, Maz, reference monitor, Maz
Replacing the Mazen,
use of all tape formats, which are at your fingertips
Austaschen of Macs
beter ask liedvorsingen begging, etc. .. * g *
Then we use the mojo from another room (2) and the fact running.
Conclusion, this one is broken mojo ... from the other room is ...
But now the hammer and we stuck the Mojo seemed troubled from the first room in the other cutting room (2) back (from the work we had brought, and from the Mac comes synonymous, we occasionally had to test umgesteckt)
There are no more problems and you can suddenly have this Mojo Eindigitalisiern yet again ...
I wonder what was going on?
lg Lena
Antwort von xandix:
Hello,
Mojo maybe overheating? (in rack?)
Until rübertragen in the other room and connect (not imRack)? it has cooled down again and work again.
I have repeatedly of problems with the mojo zuheiss be heard ...
gruss
Antwort von Lena:
Hi
Thank you
I do not know quite sure when the Mojo was not even lukewarm reconstruction and it is synonymous free standing and not incorporated.
But I will watch next Sauche sure, maybe the wars yes but ...
lg
Lena
Antwort von Puls:
you have the mojo of the tests wärhend times rebooting?
