Frage von aviator2007:
Hi folks,
I work with pros and VideoStudio10 have the following problem.
I have a video with my Panasonic GS400 EC recorded in 16:9
(PAL System) and the (. Avi) now cut scenes
After rendering with the 16:9 setting, I have in DVD format ONLY when watching on TV (no 16:9 - with only 4:3 letterbox)
the problem of the upper and lower rows (not the letterbox but the movie!) strongly flicker (especially visible on white background).
When the PC monitor, this effect is not visible!
Can someone explain to me where the fault lies there or how I raubekomme flicker?
(a compatibility problem PAL - NTSC is not obvious!)
had the following Render Settings
-> Only compatible MPEG files do not convert clicked
-> HQ 16:9
MPEG files
24 bits, 720 x 576, 25 fps
Picture-based
(DVD-PAL), 16:9
Video data rate: Variable (Max. 7000 kbps)
LPCM Audio, 48000 Hz, stereo
I have the post again in the Ulead forum set
because it is synonymous, but a general problem might know
perhaps people are not synonymous in the Section Ulead look ...
Thank you for your comments!
Sebastian
Antwort von Markus:
... while watching on the TV (no 16:9 - with only 4:3 letterbox) the problem that the upper and lower rows [...] strong flicker ... This is in many camcorders unfortunately completely normal. Pruning the Picture when exporting just those 1-2 lines. The time I always synonymous.
Incidentally it may be synonymous with the 4:3-Picture to such effects, but as you can see they do not usually. Only s.Studiomonitor with underscan circuit, they are visible. ;-)
Antwort von aviator2007:
Hi Markus,
thank you for your quick reply!
You're right, it is 4:3 at synonymous.
Is this really normal? or is it not a mistake at the Camera ...
yes ... it is not in the spirit of the inventor
I do not know whether the video with the studio is so easy with the off!
Sebastian
Antwort von Markus:
yes ... it is not in the spirit of the inventor For the purposes of the inventor was not sure, but with the line hopping nunmal went hand in hand ... see
Antwort von LaCaroratcha:
Hi Markus,
thank you for your quick reply!
You're right, it is 4:3 at synonymous.
Is this really normal? or is it not a mistake at the Camera ...
yes ... it is not in the spirit of the inventor
I do not know whether the video with the studio is so easy with the off!
Sebastian such a cropping / crop function ...
if it is nothing to trim, then you can picture a little enlarge synonymous, so that the line flickering grade is no longer to be seen ... but have to be careful that you do not have keyframes activated, otherwise the image moves
Antwort von aviator2007:
I will me the professional media studio, because
mans can determine crop
Thank you both s.euch
Sebastian
Antwort von Markus:
if it is nothing to trim, then you can picture a bit synonymous enlarge ... That should avoid, because otherwise the whole Halbbildfolge must be recalculated, which is usually with a visible deterioration in image quality and long render times observed.
If there is no cropping feature is rather to create a mask, which the concerned picture hides rows.
