Hi,

I am a second-hand Panasonic WJ-AVE55 fallen into their hands. Unfortunately, there is a WIPE controller with a problem:
He seems hinauszusteuern about his field. This is now going to explain something stupid, I try it once.

I choose WIPE as a transition mode. As a source for the A-bus, I chose the No. 2 source for the B-bus, the No. 3

Now I push the slider all the wipe-up. As a result, I see mainly the Picture Of Source 2, however, been synonymous the source 3 and the Picture in such a way as if it were possible to wipe-controller already midway between A and B. Now if I move the slider towards the B Einblendeeffekt jumps on top and I can blend perfectly normal until the regulator. Shortly before the slider reaches the final position of B will appear in the Picture Source 2 in full size. Once the controller but the final position (achieved s.Anschlab at B), I can already see the picture again from source 2 as a fade (and indeed the way of where would be No. 3 at No. 2 and the blend knob in the middle ).

I would now like to know if anything I did wrong. Despite intensive study of the manual, I could not find this behavior there.
I have found a point Reboot (probably due to the description) to reset to factory settings, the man with a Power-On with while pressing the Enter key can trigger button. But this has not helped synonymous.
Do I have to calibrate this control nor in any way? Or I have bought a defective unit?

About your help, I am very grateful.

Regards

Andi