I have a few days ago, made a cut, but now I like to take back.
However, I can "undo" is no longer used, since a few days before it happened. Is there a little trick on how to cut back again takes?
Thanks for your tips.
Antwort von tsaG:
what with all the world you cut?
Antwort von Andreas_Kiel:
"tsaG" wrote:
what with all the world you cut?
... should be composed of the forum names :-) After a few days work "undo" most software for None - unless it is continuously running and the project was not closed interval. Perhaps submit APP yes old versions as Project backup file (or *. BAK) to?
Antwort von MuFim Productions:
If the basic manual setting is not changed, sets premiere every 10 minutes to a project file (ie 6 per hour). The hot *. prproj and can be opened independently. Where the subject is in editing, project managers, project goal.
Antwort von Markus:
The body concerned with is the original clip to easily reconstruct it? - The Back store any older versions is only useful if it was the last cut that you want to undo. However, these other steps synonymous affected.
Antwort von MuFim Productions:
"Mark" wrote:
The body concerned with is the original clip to easily reconstruct it? - The Back store any older versions is only useful if it was the last cut that you want to undo. However, these other steps synonymous affected.
Would I see as synonymous. If it is really just a cut that dropped the right part of it off and trim with the left part of the gap again.
Antwort von MuFim Productions:
"Mark" wrote:
The body concerned with is the original clip to easily reconstruct it? - The Back store any older versions is only useful if it was the last cut that you want to undo. However, these other steps synonymous affected.
The shop is no going back. Each of the saved project files is an independent project. You copied and open the old, removed everything that is not in the current project file to be used and save the project as a new file. This new project file is then like material in the current project file. Of course only makes sense if the faster than a change in the current file. But that takes ponlur perhaps, otherwise he would have been very little demand.
Antwort von MuFim Productions:
Thank you for your answers.
I will try your suggestions. My Software (APP2) runs only in English, I had forgotten that "Undo" Undo means ...