Frage von Quacks:
Hi
I have a Sony camcorder in an adapter used for a teleconverter.
Now I wanted to use the fisheye is violent but I get the ring that is screwed directly in front of the lens does not back down, because nothing can be done with raw, and before I completely tear apart I wanted to ask for the tips to solve this .
thanks
Antwort von xandix:
In the automotive area, there are "screw remover.
Perhaps so gently spray.
Perhaps sowas:
http://www.pollin.de/shop/shop.php?cf=detail.php&pg=NQ==&a=OTM3OTg0OTk =
Antwort von shipoffools:
In the automotive area, there are "screw remover.
Perhaps so gently spray.
Perhaps sowas:
http://www.pollin.de/shop/shop.php?cf=detail.php&pg=NQ==&a=OTM3OTg0OTk = Just not with something close to the lens and rumsprühen on plastic!
Then you can probably scrap the camcorder.
The issue with the fixed adapter ring was discussed here in the forum pretty often, including
here.
Antwort von peha:
Hi,
I once solved a tight fit gray filter by turning the filter ring
(; down along with camcorders) on the table for a piece of Suede lying down and then the lens was rotated. Possibly. gehts synonymous with with a sponge or similar
Gruss
Peter
Antwort von Quacks:
Ok thanks.
So apply but violence. Will try it again so with even more force to get otherwise, such a Hama solver.
What do you think of the alternatives and let drinne before nen Spacer?
Antwort von Meggs:
I had the problem a few times already synonymous. The adapter always went down again. However, after some time and try again.
