Frage von Neuling:
Hello,
Conversion Calculator for an Adobe Encore can not boot. It runs on WinXP Pro SP1. Before, everything went perfectly. Also remove or repair has been the program anymore.
Immediately after the launch of the calculator goes down and restarts. That's not normal? Can someone help me?
Thank you very much
Antwort von fabriquez:
What have you rebuilt it? Mach mal drauf SP2.
Antwort von Markus:
What have you rebuilt it? Mach mal drauf SP2. The first part, I agree the second part, I strongly advise against. As long as the cause is not established, it brings nothing to install any flat things. Especially with SP2 may still occur entirely different problems (keyword Firewire).
Antwort von fabriquez:
Yes may be, we should have rather put a system and re-install SP2 directly with. Afterwards, I would not make it synonymous on it. I have a system with SP2 and it runs everything synonymous Firewire. I was advised the synonymous of our support, where we bought the cutting machine.
Perhaps you have a lot of Encore registry entries, delete, try this time to manual with a registry editor. Then install again new.
Antwort von Markus:
There are, in fact, software that requires SP2. Luckily, the video section still rare in the case, because this service pack is always synonymous carries the risk that one day may occur quite unexpectedly, a problem with firewire.
Example:
Program can not access the Camera
