Frage von Budoudo:
Hi,
I would have a Canon 50mm 1.8 Lens and fix them a focus ring.
The rings are as follows:
http://www.freshdv.com/wp-content/uploads/2007/01/redrock_micro_follow_focus.jpg
The problem: The focus ring s.ist narrower than with other lenses and so slipped from the focus ring for the follow-Focus. because someone has a solution?
Thank you
Budoudo
Antwort von Axel:
Schmeide an old bicycle inner tube in a 5mm wide, but very long strips, so you do this several times for relining can wrap around the lens. With a large variance, there are rubber strips of approximately 4 mm thickness (white does not know where the were here, looks like the makeshift Schuster "Mr Minute").
Assemble the rings s.den lenses and
leave them there, or you will go mad. Buy you a larger lens selection rather more tooth rings. Which are synonymous with no-slip FollowFokus for normal operation.
Antwort von Budoudo:
Schmeide an old bicycle inner tube in a 5mm wide, but very long strips, so you do this several times for relining can wrap around the lens. With a large variance, there are rubber strips of approximately 4 mm thickness (white does not know where the were here, looks like the makeshift Schuster "Mr Minute").
Assemble the rings s.den lenses and leave them there, or you will go mad. Buy you a larger lens selection rather more tooth rings. Which are synonymous with no-slip FollowFokus for normal operation. Thanks Axel, I will try once, it would actually work already.
Greeting
Budoudo
