Frage von cirE:
Hello @ ll,
got there a little problem. This morning I interviewed with a colleague a few passers-by in the pedestrian zone.
Cam: Canon XM1; Tape: SonyDVpremium (ME DVM60)
Now I have the problem, which the band coding (indoor) and the first passer-by to watch the tape. No errors, just fine. After the first "cut" can be seen, however, only the pre-existing video footage. The tape has been used, although schonmal, but that should not have to be sooo bad that nothing will come again.
At any rate, I have now only the first woman on tape and in between I can see individual segments, sometimes only half-images of the other passers-by.
The pictures I have of me, smeared his cheek, but still'd like to know why this is!
Possibly. s.der cold? It was approximately 8-11 degrees "warm" - n bit windy. But that would still go or not?
Upsets me jedenfall good at ^ ^, oh well .... There are other nice days.
Thank you in advance ....
The cire
Antwort von Stefan:
Tape: SonyDVpremium (ME DVM60) Switching times, perhaps the band locations.
Good luck
The fat Stefan
Antwort von cirE:
Hmm ... what can you recommend it? Did the same time yesterday, tape inside can pass, as they timecode jumps etc. not seem to be. So you mean the tape is to blame? Would not be bad, at least cheaper than a new CAM;) erstmal danke!
Until then, the Jan
