Hello s.alle I have problem, my XL1 is broken, so it is absolutely not turn on, check in at the Canon service, was told that the main plate, My board is broken, and the repair should cost 900 ¬, so the rest of the head, and other components are in super condition, someone knows where I could record a major favorable, or has someone to sell something? Or did anyone here a good tip? Thanks for the help in advance MFG Adam
Antwort von Surty:
Is this not a case of warranty? If the manufacturer does not pay?
Antwort von vicky:
XL1 was only sold until 2001, then came the XL1S, so unfortunately no warranty!
Antwort von ruessel:
It is usually just a loose ribbon cable or a defective Elko .... before the camera comes in the garbage, I would point s.deiner times yourself .... worse, it can not be.
Antwort von Maik:
"trunk" wrote:
It is usually just a loose ribbon cable or a defective Elko .... before the camera comes in the garbage, I would point s.deiner times yourself .... worse, it can not be.
haha. Then I'll argue that you do not board an XL1 in hand 've had. Without oscilloscope, electronic manual with a description of the measurement and without SMD Lötausrüstung can be as simple and moving nullkommagarnix make. And that it only s.einem broken ribbon cable is: qed.
If you simply turn on a circuit garnicht happens, then is first to suspect that a deadline or a disruption in the primary power supply exists. This may be a broken fuse, a defect in the voltage conversion (if available), or in a subsequent circuits mean (order Difficulty in the repair, ascending). Even with a measuring all components durchgemessen means nothing: a Elko under tension behaves entirely differently than just 'dry' capacity measured.
M.
Antwort von ruessel:
Quote:
Then I'll argue that you are not yet a motherboard XL1 held in the hand searched.
Right.
but I have been a faulty DV camcorder to get a gift Ausschlachten (supposedly repair costs 600 euros - Electronics error), then I needed only the ribbon cable from the motherboard to the drive to plug something schwupp and ran as part of the new. It does not always have the board really completely defective .....
what should he do otherwise? Remains only the garbage ......