Frage von Mannimanaste:
Hello,
It's about the program ULEAD VideoStudio 10 Pros.
It says in the instructions on Page 79, Item 7, that you can summarize some of the separation at the scene saw scenes in a single clip. One should select the relevant scenes, and then click Connect.
I think we should, the scenes in the upper right window, highlight, and all in edit mode ...
So not in the project window below.
But unfortunately I think a lot Rumsucherei anywhere a command which reads after the marking of two scenes Connect.
Am I blind or did I understand something completely wrong or missing in my program even 'ne button?
Thanks for any help in advance
Gruß,
Martin
Antwort von Georg:
The window for the auto scene separation is intended. There are the buttons "Connect".
Antwort von Mannimanaste:
Hello Georg,
Thanks for the info.
Does this mean that I am now, after the scenes are separated for a long time, now can not combine separate scenes merh?
It would be really not so bad, but it would be quite useful just now when I see the reworking of automatic scene detection separately continuous scenes, some only because a sudden change of light had to be able to connect these scenes synonymous again later ...
Gruß,
Martin
Antwort von Georg:
Alos just as I can see the link to the archive no scenes, but only in the function scene separation. The only crutch I can think of: all the scenes to the bottom film to delete the archive and call on the first Filmicon again Szenetrennugn. Here are the Lsite ncoh is indeed there. Then connect the required scene here and can resume exporting to the archive. Goes relatively quickly, but it is cumbersome.
Addendum:
I once registered a wish here:
http://www.ulead-fanboard.de/thread.php?threadid=3545&sid =
Antwort von Mannimanaste:
Hi George,
thanks for the tip. Synonymous with the idea I had already come, but I hesitated because the scenes might not be identical to recognize how right the first time, and besides, it is obviously inconvenient, and in the long run this way 'no work'.
Also, I was sure that somewhere this retroactive-scenes liaison role would be, because, as you already in the not uninteresting Fanboard thread relating to write: Pinnacle can do it. With MAGIX is synonymous Incidentally, as I recall ...
Well, the above two have it otherwise so serious shortcomings that I am still happy to finally landed at Ulead.
Mal ne yet another question:
Could it be that I have understood correctly, that you can cut trim with Ulead Studio 10 pros several times mainly in the mode of "scenes" really comfortable and well, or I've got other ways not yet understood well enough?
Thanks for the entry in ulead Fanboard.
Should I ask questions to Ulead studio 10 pros might prefer there??
Gruß,
Martin
Antwort von Georg:
You have) the possibility of the blank in the timeline (the big zoom, or as in the preview area on the time setting.
To the forums:
Where are you probably because you feel let down.
I stopped running a special Ulead forum and am there often natrülich found.
