Frage von my44:
Hello PanasonicFreunde and "expert?"
I own the last 4 years the above camcorder. I'm very pleased with the beautiful and successful recordings have made it.
Now, the "start - stop button stops responding.
By remote control, I can use the camcorder well, but is very cumbersome.
Tel on demand at Panasonic Service Center I learn, the cost will amount to approximately 200 - 300 ¬ - where there is no further damage, except probably the defective board.
The unit cost me about 1000 ¬ (4 years ago).
Should I find a cheaper solution, it seems appropriate to buy a new camera to be better.
Nevertheless:
Has anyone an inexpensive ideas ???????????????????????
gruss
my44
Antwort von Stefan:
For spare parts: If this camera has a jack for an intersection control, then perhaps you can connect a cable with Male and switches. Thus you would have an alternative button start / stop.
Links to DIY:
And therein http://www.heise.de/ct/98/07/200/ Article
http://www.slashcam.de/info/Universal-LANC-Handling-selber-bauen--109066.html
(not the LANC but the Ebay-boxes and the discussion)
Good luck
The fat Stefan
