Frage von superurmel:
I have a video created in Magix. The video do I export a PAL DVD and it shows stripes when I play on the PC. So far so good, with interlacing etc has to be done.
What must I do to my video in DVD quality on a beamer to consider? Have read that a VGA port (laptop> beamer) is not the right way. Is that correct?
If I have a DVD player via the video input connected to the beamer, it works then? I can not yet test myself, since I received the projector will borrow until tomorrow.
What preparations must be taken? Must be the video in a certain format?
Thanks in advance.
Antwort von Markus:
Have read that a VGA port (laptop> beamer) is not the right way. Is that correct? Yes.
If I have a DVD player via the video input connected to the beamer, it works then? Also yes.
What preparations must be taken? Must be the video in a certain format? MPEG2 in VOB container, burned as DVD-Video, so that they have a DVD player can play? - Or what your question is aimed from?
See synonymous:
To ensure maximum compatibility: DVD-R or DVD + R?
Antwort von superurmel:
MPEG2 in VOB container, burned as DVD-Video, so that they have a DVD player can play? - Or what your question is aimed from? Yes thank the synonymous.
I wish the video presentation via projector. And of course in sharp resolution.
1. What quality should I export the video? (PAL, 720p, 1080i, etc.)
2. Have read that the DVD player and a digital output of a digital projector input is needed. Have an older DVD player. The Question: The coaxial digital output is not it? Have here
http://www.etest-heimkino.de/test_guide-485-kaufberatung.html#3cQuote: http://www.etest-heimkino.de/test_guide-485-kaufberatung.html#3c... Do you own a television (or projector) with digital inputs, you need a DVD player with digital outputs. Among the digital video outputs include DVI-D, DVI-I and HDMI .... http://www.etest-heimkino.de/test_guide-485-kaufberatung.html#3c
3. If I use the video once on a tube television and even the presentation with the beamer wants, then I need but actually 2 versions right? Once for the Television in PAL quality with and once without interlace Interlace? (Or does the beamer) aaaargh * *
Sorry if I confused a lot and write stuff. Is urgent. My sister married s.Samstag have finished the video and am not sure whether the quality with what will. I was not so aware that I am against such problems is. Covered film making in DVD quality and ready for export.
Thank you
Antwort von Markus:
1. What quality should I export the video? (PAL, 720p, 1080i, etc.) A DVD-Video delivers maximum DV / PAL with 720 × 576 pixels, with their own videos usually interlaced. - Which format is the Project? A higher resolution? HDV, AVCHD, etc.?
2. Have read that the DVD player and a digital output of a digital projector input is needed. And for what is needed? For the video transmission is not in any case. Since it is sufficient in the worst case of a composite connection and better event in Y / C, RGB or YUV.
The coaxial digital output is not it? Yes, but it's not for Picture, but for the sound. ;-)
3. If I use the video once on a tube television and even the presentation with the beamer wants, then I need but actually 2 versions right? No, not necessarily. Unless the original project is in a better format than DV / PAL before and the higher resolution set as synonymous to the projector over. It would then no longer with the DVD-Video.
(Or does the beamer) aaaargh * * A beamer will
always be a s.Video input by deinterlacing. That he must do, because otherwise ugly interlace strips on the projection screen would show.
A Council s.Schluss: Check the DVD necessarily in that DVD player, which they later give. Not that it precisely fails (see my link above, synonymous).
Antwort von superurmel:
Thanks for the response Mark.
1. The Project has a Resolutionvon 720 × 576 pixels. Did that with Fraps trips to Google Earth. And it was only in this resolution, since higher resolutions had overwhelmed my CPU and the picture was restless.
2. How do I close it because the DVD player s.den Beamer? About the composite output?
3. Does the coax is for the Sound. The picture goes on Scart.
Thank you
PS. Markus Maintal you come from? Then look here
www.matchsticks.de
Antwort von Markus:
The Project has a Resolutionvon 720 × 576 pixels. Then it becomes a DVD-Video and ready. Check the pictures previously s.Television whether something flickers. This should be remedied before.
How do I close it because the DVD player s.den Beamer? About the composite output? Since it is sufficient in the worst case of a composite connection and better event in Y / C, RGB or YUV. Déjà vu ;-)
Our tape has its "seat" in Maintal :-) And then again someone will argue that the Web would remove the people from each other. ;-)
Antwort von superurmel:
One last question in connection with the PAL Resolutionund the beam projection.
How much can I contribute to the Picture s.die wall? Eventually it will be pixilated or?
Antwort von Markus:
Eventually it will be mainly dark and flat. ;-)
