For uploading to YouTube Ideally, a complete cut in Premiere Video levels generally like a little louder, so that it corresponds to approximately the same Youtube-hour volume down. But how? If anything for all I Comp in a new insert and gain, the result is already at +4 or +5 dB Over a strong control on the rendering. \u003cbr /\u003e\u003cbr /\u003e Clear, loud parts are generally more down-leveled and hochgepegelt not quietly - already clear. For the final I would like to export the video, but much louder. Do you have an idea? \u003cbr /\u003e\u003cbr /\u003e Regards, Fabian
Antwort von soan:
Once you have achieved through the proper setting and adjusting of your contribution to the "maximum level" (maximum is 0 dbFS, that's the end of the flagpole - overdriven is then digitally and destroyed the signal) you can transfer your contributions make only by dynamic tools "loud" . You amplify eg by use of a compressor, the loudness impression. The level is still up to 0 dBFS (unless the tool is not set correctly, observe output), but overall the article seems punchier. \u003cbr /\u003e\u003cbr /\u003e If your film you in Comparison to other videos too puny appears you have probably leveled him wrong before export (please examine). Maximum level of the clip should be as-9dBFS dbFS to -6, then you have a little Bissel headroom before it mercilessly overdriven
