Today my new behringer C1 tried everything beautifully ...
then I take in my recording studio''''(very many rooms with ceilings ... no reverb, noise etc.), suddenly, it is relatively quiet. I play me a time and go with the Micro in my editing room, which is not damped (Leave all settings as before) suddenly is all very loud and clear to ???!!! what is going on, but a recording studio should be curbed!?
What is my problem? I understand this is not (and s.Sonntag I sync my film!)
Asking for immediate help or tips! Thank you
Antwort von ths:
Hmmm,
Tonheini seems to me that the correct user name to be .. Ähhh - any little clue or plan of the Matter -?
probably njet ... alone Behringer Microphone-election for a "Syncronstudio" with blankets and pillows ... is one thing to breathe deeply ...
No - to such questions should you refuse to answer --
Antwort von Markus K.:
Do you have the right of the Page in Microphone spoken?
Funny the way, that a micro Behringer Phone with a large 16mm diaphragm capsule as a microphone sold ...
Antwort von noname:
I am not at all with the Microphone from but it is perhaps s.dem oneself cable?
Antwort von thos-berlin:
404ERR
Antwort von noch n´Gast:
mal blöd asked: could it be that even more times on the "too long" cable rumgetrampelt was, and so now the transfer, or perhaps synonymous phantom power does not work properly?
Antwort von Schleichmichel:
@ Tonheini: One of your problems is in any case that you are not clever can communicate what is happening. So as you formulierst, so I understand that the Microphone in the recording area "is less sensitive than the" control room ". Sun, and that we will have to explain?
Look up your cable s.and test by yourself! The subject matters may s.1000. And it seems to work, right?
My God, what must happen for a few bad people have been before the Internet was ... google how to make a sandwich lubricates ...
Antwort von noname:
Yes ok I've said too little!
I know how to use this Microphone bedint (Page, etc.) It is s.Kabel, which has a bad contact.
Thanks for the answers
Antwort von Markus:
"Tonheini (without naming names)" wrote:
It is s.Kabel, which has a bad contact. Thanks for the answers
Is the issue that's not already clear? New / better cable ...?!
