Frage von Markus Nbg:
Hello
have found in ebay for Sonypc1e me worried the cable for the DVIN Activation. On the computer of my kids is still installed win98 but I always get an error message. So I'm s.meinen win 2000 Calculator and ran the Dosprogramm. Parameters according to instructions changed. Now, the battery display will flash briefly and the cam switches itself off. Scheibenkleister ....... by switching off, I can now change anything. Help what can I do now still ...........
In a similar contribution Achim wrote, "There is a DOS program, with whose help it (as opposed to the" emergency-button ") managed to unlock the camera." what program is it?
Please, no slogans "stick to your last"
Thanks for reading
Markus
Antwort von steveb:
http://lea.hamradio.si/~s51kq/ DV IN.HTM
you help me?
Antwort von Markus Nbg:
steveb
Thank you for your Abtwort.
Browsing through net I'm already landed on the page and had me the org. Dump-file views
.
Imm forum I've been found dvzone of Hansi, the solution has the following contribution.
1. Read off:
- Page: 00 Addr: 01 -> Data to 01
(Here you can apply changes to Page: 0D conduct, sh. Below)
2. New checksum note:
- Page: Set 02, Addr: F0 set and write down the value of Data: 02: F0: xx
- Page: 02 set Addr: F1 set and write down the value of Data: 02: F1: yy
3. Checksums Update Enable
- Page: 00 Addr: FF -> Data to 02
- Page: 00 Addr: 01 -> Data on 80
4. New checksum register (the values of point 2):
- Page: 0F Addr: FF -> Data on the value of xx and [write]
- Page: 0F Addr: FE -> Data on the value of yy and [write]
5. Read reactivate:
- Page: 00 Addr: FF -> Data on 00 and [write]
- Page: 00 Addr: 01 -> Data on 00 and [write]
Now, with [Esc] to remove RM95EMUL and unplugging the LANC cable
Cam and remove power off - after about 5 seconds power back to it
=> The cam should now be entblocked!
So with out RM95EMGY unblocked and RM95EMUL with the changes.
Gruss Markus
