Frage von biohazard_ffm:
Hello,
for the recording of a concert with 3 cameras I was looking after the "best" solution when the photographs of postprocessing synchronously possible to have available. It is 2 Canon XH A1 and a JVC 5100th
What method can you recommend me da?
Antwort von jansi:
Have you already made the recording?
If not, then necessarily
s.nie the breaks in the recording stop
b) once before with the "flap" (film damper, etc.) suggest
c) Please do not start at the same time, if it is a piece of acting, where you have more than one tape using (otherwise you backed them up, on average, you are missing to hire 20 sec.)
Antwort von biohazard_ffm:
Have you already made the recording? No. :-)
If not, then necessarily
s.nie the breaks in the recording stop
b) once before with the "flap" (film damper, etc.) suggest
c) Please do not start at the same time, if it is a piece of acting, where you have more than one tape using (otherwise you backed them up, on average, you are missing to hire 20 sec.) The main problem is probably that the XH A1 does not have TC and therefore out of sync later on the flap should be done?
And therefore never synonymous to stop the recording at any rate at first tapes synchronously to have everything? Only after the first change will be so few seconds difference between the bands to be.
In any case, thanks for the quick reply.
Antwort von biohazard_ffm:
What does it with a TC-Gernerator from the info on the soundtrack to XLR test?
In particular, Vegas or Premiere then synonymous show?
Antwort von PowerMac:
Free-Run-Time Code at all, then sync only once, done. Perfect for multicam.
Antwort von jansi:
And therefore never synonymous to stop the recording at any rate at first tapes synchronously to have everything? Only after the first change will be so few seconds difference between the bands to be.
No, only until you've laid again synchronous.
on TC out is of course a possibility (yes when you is not, how have you been told), but is not required.
Did you sync the clips first laid, they remain synchronous synonymous, unless you've got in between the recording is interrupted, then you can re-synchronize.
You do not need timecode flap, just the 3 clips, so put that in all 3, the flap at the same time play.
Antwort von xracy:
... ne is not exactly fine method, but it has worked for me several times.
instead of using film damper with a flash sync the cameras. - Has the advantage that nobody on the stage to go, what places can not be synonymous. (the lightning in the background set. - has sent me in the postproduktion significantly spared my nerves)
xracy
Antwort von nexxt:
instead of using film damper with a flash sync the cameras. But then the shutter of the camcorder up to hunt, otherwise it will be a matter of luck that is precisely the frame of the flash is recorded.
If you want to make it right, then makes it about the time code and represents the TC of each on real camcorder.
Antwort von UlmsSkyliner:
In this thread are some helpful hints called.
If yes no preference whether 2 or 3 cameras, it's drum with multiple cameras to film :-)
http://forum.slashcam.de/zuruck-vt47848.html?postdays=0&postorder=asc&&start=0
MfG Chris
Antwort von PowerMac:
instead of using film damper with a flash sync the cameras.
But then the shutter of the camcorder up to hunt, otherwise it will be a matter of luck that is precisely the frame of the flash is recorded.
If you want to make it right, then makes it about the time code and represents the TC of each on real camcorder. Completely rubbish. The shutter rather lower (s.besten 1 / 50 second) to make.
Antwort von biohazard_ffm:
Thanks for your answers.
Let's see how it works. :-)
