Frage von robert parris:
hello zusamnmen,
I have the following problem Nervendes me to death. I will of miene sony fx1 digitize about premiere. with the camera after I digitize provbleme when I did I still have the hdv recorder (HVR-M10E concern).
thus synonymous tag s.ersten everything went pretty well, apart from the times I needed a student 3 shall expire at the dingzum bring. The problem is synonymous I after I got him to run, not uwsste why it works now .... very tricky ... da nich repeatable
naja ... Next day .... And the odyssey begins in front of ... the hdv-rcoreder is entwder by the system as a 61883-class gets recognized ... and incorrect or incomplete installation, or it detects an AV / C band gets ... as it actually should be, deletes the entry again after 10 seconds ....
But the worst is when everything seems to be good but for the premiere and then perish nich in the location is open the caputrefenster to ... block would be as if the firewire interface anything.
My computer is technically ausstattungsmäßig or should not be the porblem. P4-640, 2GBram 400GB raid0, winXP SP2, premiere 1.5.1
I hope one of you can give me nen tip, why so gets abspackt .. is really corrosive .....
I see me back again s.mein old dpsvelocity .... but still not affordable in HD is ...
Many thanks and greet
robert
Parris-BEI gmx.li
Antwort von Markus:
Hello Robert,
I type the following reason: SP2. Information about this you find in the following link:
http://www.videoforum.de/cgi-bin/yabb/YaBB.cgi?board=allgsoftware&action=display&num=1108029846&SID =
Love Greetings
Markus
Antwort von robert parris:
so ... The problem is now solved for the time being
After I uninstall service pack2 and then re-installed the firewire patch installed and also have it running now ... for the time being (until the next system start ;-)) and equal synonymous with kinternet ....
However, I hope that everyone who needs to deal with the same problem set is so smart search the internet for the solution and to find one here to be .... because you think the whole of nich alone can .... bad ... ;-)
again thank s.markus ...
viele grüsse
robert
Parris-BEI gmx.li
Antwort von robert parris:
: Hi Robert,
:
: The patch does not always help. SP2 uninstall completely from the Calculator and
: Try it again. (Good luck)
:
: Love greetings
Markus
argh .... ;-(((... But ok ... what one does not everything ...
this right is indeed incomprehensible ... that my laptop (asus m6762) has no problems with the device or with the premiere ... mal apart from the machine-service nich (he goes centrino 1.8 ).... but it funzt ...
hm .. well now .... will now uninstall sp2, then install the patch again and drüberjagen ...
And then have come back around 2 hrs ... And nochimmer no further digitized video ...
CORROSIVE!
;-))
Thanks for the tips markus !!!!!
viele grüsse
robert
Parris-BEI gmx.li
Antwort von Markus:
Hello Robert,
the patch does not always help. SP2 uninstall completely from the calculator and try again. (Good luck)
Love Greetings
Markus
Antwort von robert parris:
Hi markus,
Thanks for the tip, unfortunately the link is down ... but I still found the fix.
http://support.microsoft.com/kb/885222 However, it has not been corrected at me problkem ... for the time being .. am still a little trial and error before I put the head in the sand ... Yesterday, the computer then tracks again! ;-))
thank you very much
regards
robert
