Frage von Fengshui13:
Hello,
I have the following problem. I need speakers for a XLR connector. this should be split but once in and once xlr chinch. someone knows such an adapter, or can tell me how I would have to solder it together?
lg
sim
Antwort von Markus:
I need speakers for a XLR connector. That suggests that the speaker wants to be symmetrical.
this should be split but once in and once xlr chinch. Is mostly balanced XLR, RCA, it is definitely not (can not be, since only 2 poles instead of 3 as XLR). It is therefore no simple adapter solder, both of the outputs, because otherwise you would XLR connector unbalanced synonymous same make.
Instead of a power could be but a small audio mixer to use, from the balanced XLR signal is asymmetrical. However, then the question of what level the XLR signal? Audio Mixers process usually Microphone and Line-level, but if as a passive loudspeaker is activated, it is a much more powerful speaker signal.
I hope that was not too much jargon ...
Antwort von fengshui13:
I thank you. The mixer will try variante. I always wanted a growth.
lg
sim
Antwort von thos-berlin:
The combination of RCA and XLR I am on active speakers. This can be directly s.einen Line connector (preamp, mixer) and need to connect the next Tonanschluß a power.
Passive speakers with clamps, jacks, (the amateur) with speaker plugs, Speakonanschlüssen or with 3-pin XLR connectors (of which only two poles are used) s.einen amplifier.
Is my presumption "active"? Do you have two speakers, which are adapter? One with an RCA and XLR with?
Antwort von kosi:
Or try it out just sowas!
http://www.ta-multimedia.de/product_info.php/products_id/3059
Can you imagine yourself synonymous very easy to solder. The XLR Male has 3 pins, with the 1.2 and 3 are designated. 1 is the mass that you need most with the 3 (cold) and 2 connect the "hot" pin.
Here synonymous with pictures.
http://www.hifi-forum.de/viewthread-42-6.html
Antwort von PowerMac:
The thing is called "RCA"! People think it out after. With "h" after the "C" spoke at the quite different!
Antwort von felix75:
Can you imagine yourself synonymous very easy to solder. At a price of 1, - EUR is probably only for hardcore hobbyists and if the store already has and the thing you absolutely need.
Even with a Neutrik adapter of the self would not be worthwhile if one calculates the material and time (unless you are quite free of pain or must turn around three cents each).
