Infoseite // Pinnacle 12 and Panasonic Cam - What to do?



Frage von waterangel:


Hi All,

I am still annoyed about 2 hours to try something and hope that I forget any important details now.

I got for my birthday, the Pinnacle 12 and wanted tonight to start the dubbing of videos of our Panasonic NV-GS280 too. With USB, I have not gone far, so screwed Calculator, installed the firewire card (; good that here at some 1 / 2 year was ...;)).

Now I have plugged it on DV, PC mode switched on - not recognized by the PC. USB hats earlier times, at least a little "Hello" said - but he now makes synonymous anymore.

So - I sit s.einem PC with XP Service Pack 3, an NV-GS280 and have Pinnacle Studio Pros 12th What can I do that I get all this together? I searched the forum, but unfortunately found nothing. Pinnacle at getting the message that "no studio is able to recognize my device attached to equipment.

Hope to one or more helpful answers!

Thanks, Greetings & Good Night
Regina

Space


Antwort von opel:

Hello,
The message that Pinnacle does not recognize the connected equipment, is well known to me.
1. Only immediately connect via Firewire or analog via RCA connectors.
2. First start up the software and then connect the camcorder and turn them until then.
Also Please go in the match Minimalanfordrungen in Pinnacle 12 with the configuration on your calculator.
Basically, that asks what Pinnacle, a minimum requirement, which should (at least, are complied with memory), better exceeded.
The version 12 requires a high computing power with a minimum of 2 processors.
Off all other processes, then it should work out really.
If not, install Pinnacle again, but first remove and examine exactly (; Regedit), if everything is really down.

Space


Antwort von Bruno Peter:

Quote: I searched the forum, but unfortunately found nothing. Pinnacle at getting the message that "no studio is able to recognize my device attached to equipment.

1. For miniDV you do not need high-performance PCs
2. For the detection camera via Firewire interface is the operating system is responsible, not Pi Studio Do not look in the manual in the forum!
3. What you need to do is in the detailed manual, detailed gehts kaum noch!

The PC system is obviously skewed. Format C: and reinstall the operating system current with new drivers, then the program and the PC will recognize the camera with safety!

Space



Antworten zu ähnlichen Fragen //


Pinnacle 12 and Panasonic Cam - What to do?




slashCAM nutzt Cookies zur Optimierung des Angebots, auch Cookies Dritter. Die Speicherung von Cookies kann in den Browsereinstellungen unterbunden werden. Mehr Informationen erhalten Sie in unserer Datenschutzerklärung. Mehr Infos Verstanden!
RSS Suche YouTube Facebook Twitter slashCAM-Slash