I am trying desperately for some time HD footage of a XHA1 with capture to Premiere CS4. Windows 7 recognizes the Cam does not even premiere. The cam can be controlled via Pr, however, although the material is not recorded. A plugin for Hd movies I've already installed.
I hope the s.Informationen last.
Regards, Frank
Antwort von Axel:
A plugin is not necessary. The Project must be preset HDV are (in the case of "f" 1080 "p", or "i"). camera side must be chosen in the menu "DV = HDV out," it is not, the Firewire connection will be disconnected, and only then is the selection (previously grayed out) is possible. Irritating for DV familiar, is that there is no preview during the Capturing.
Antwort von freako123:
I have the cam now if I could capture ". funny thing is HDV material can be only in DV mode and capturing DV footage in HDV. Where can I press REC, unfortunately I get the message that no frames were taken. Could it possibly be synonymous s.einem defective Firewire cable? Taxes, the whole can in any case on the Calculator.
Yes, the drivers are already updated. However, I have not found the setting for the "old" Drivers.
Antwort von freako123:
SO, Drivers are set back, now I can capture HDV. Unfortunately, with DV looks bad from that can not import as before.
Antwort von Axel:
In the past all thought, Firewire would be the ultimate for video, here is the care offered (voltage peaks by touching the connector with Chen's hands can already destroy the FW-board), the order of connecting, switching and ggffs. Setting and resetting a mystery how the ritual circumcision of a Tasmanian devil. I bet you've just connected the camera to try to switch FW.
