This year I want to cut more projects themselves, and above all synonymous HD can work properly. Most likely it Mateial of Canon EOS DSLRs or XDCAM will 442nd
In the past, I unfortunately have to make the experience that the material and the XDCAM 422 H.264 44 Mbit / s native 1080p of the EOS can not be cut smoothly. Not liquid means that I get in the preview monitor is not even on the level of quality "draft" a smooth playback, that is "cut" can not speak of.
Of course I know that you can not edit any office PC with above-mentioned material, which means I've made a few thoughts as I could speed up my system. Goal, it is not more than 400 ¬ to spend.
1. Instead of using a WinXP 64-bit version of Win7, so at least once the 4GB RAM is fully utilized.
2. The board replaced with a new, so I could install 8GB of RAM. (My current is s.der with 4GB limit)
3. two hard disks configured as RAID0.
At this point I would like to ask you how far these measures contribute to a significant performance improvement, or whether it had any proposals Had.
If you are of the opinion that it makes no sense to upgrade my system so I can at least simple cuts (a few effects) achieved acceptable, then I would be synonymous already helped ...
Best regards, Martin
Antwort von RickyMartini:
I would rather recommend a new system with base 1155 or 1366!
Had the time this thread is: http://forum.slashcam.de/schnittrechner-avchd-with-sandy-bridge-vp466887.html#466887
CS5 would bring significant advantages as compared to CS4 - due to MPE.