Frage von duVan:
Hello everybody,
I have a problem,
today I have material that I am in summer and winter rotated've digitized. It has struck me as follows:
http://img78.imageshack.us/my.php?image=xl1problemfk8.jpg if you lower margins and s.die look, you will discover below black or partially transparent tape.
ask: what is this? is a mechanical problem?
s.der cassette, it is not, as appeared in several cartridges, the problem
recently I have another camera with A FILM rotated and handled, since there were no incidents similar to the present.
I am glad about every answer, because I just am a bit desperate
duvan
Antwort von PowerMac:
I had never been a XL1, but I think that is normal.
Antwort von duVan:
ok, I've read a bit through the forum, seems to be normal
mensch
zum Bild this is really shitty
let's see if on the TV set then synonymous exists, the problem
Antwort von Markus:
I had never been a XL1, [...] but this is normal. Dto. Without the addition. Old camcorder all had their quirks in Overscanbereich.
* edit *
let's see if on the TV set then synonymous exists, the problem No, that vanishes in the non-visible edge.
Antwort von duVan:
n.herzlichen thanks for the fast reply:)
Antwort von Markus:
So, that makes 5 ¬! ;-)))
Antwort von oskar-lima:
Old camcorder all had their quirks in Overscanbereich. Hi Markus,
I found this old thread, because I currently have the same problem. Do you still believe that the halt in some cams it is, or is there perhaps now is still a technical solution?
For me it looks: I cut reports, which I with my two Canons (XL1 and XM2) in 4:3 turn. It is, I noticed that the XL1 left and right a small black bar einblendet what the XM2 does not do. Previously this was no preference, because I always broadcasts for DVDs produced and have the inside edge of the overscan area is located. Now land the reports but synonymous as Flash files on the Internet and here is you know the whole picture to see.
Has anyone else any idea why this makes the XL1? Yet I could never find something about it.
Of greetings Olli
Antwort von Markus:
Do you still believe that the halt in some cams it is, or is there perhaps now is still a technical solution? Yes, these thoughts, I am still. The technical solution is that when you export the video left and right generally narrow black bars or something of the drüberblendest Picture off so suddenly at Umschnitt not have any image edges are added or disappear.
More can not do that because, unfortunately, because older camcorder will never younger. ;-)
Antwort von oskar-lima:
Tscha, which I had feared! Then I will probably have to be generally a little modest. Nevertheless, thanks for the quick help.
Gruß, Olli
Antwort von Markus:
The more cheese, more holes
The more holes, the less cheese.
Conclusion: The more cheese, the less cheese! OT: I must say, your signature is very nice cheese! But conversely, is a shoe out of the more holes, the more holes.
zum Bild
Antwort von urwoflo:
The Canon XL1 has too few pixels on the chip (320,000) to the full PAL Resolutionauszugeben, so margins are s.den just black stripes.
Antwort von Markus:
... why are s.den edges just black stripes. Then would have to strip nearly 30% of picture width to take. ;-)
