Frage von sven1178:
Hi,
now I have about 10 hours editing my film (wedding film) and now comes the following error message.
The Project requires approximately 6634 megabytes of free space on the disc
Shorten the Project.
My DVD has 4.7 GB capacity.
Clearly there is a difference, but it had already burned and there was.
Now I am totally desperate, how can I work around, especially since the preview shows me enough memory. Did the Encoder setting to 3700 is reduced, so that fit on the DVD is 2:40, 8 and quality of both crosses are placed below.
Please help me
Many greetings
Sven
Antwort von pingu2k:
The Preview (synonymous to adjust bitrate) mE shows only how much space you need, when all new material with a uniform bitrate rendered.
If you SmartRendern example, it is (or should) not rendered unchanged material (to be). Has there been a higher bitrate, and while it remains in the problems because of the place.
This leads as synonymous to the fact that - when several films on the DVD should be - it may not be enough to an already existing Diskprojekt only the newly added movie and the menus can be calculated, but all the films and menus must be calculated so that all the new films have lower bitrate and the resort preview is correct then synonymous. So I was in any case from my experience concluded.
You should therefore check the Smart Rendering and remove any question of whether you want to use existing films or recalculate want to choose the latter entry.
The dialogue should be at 4300 MB level is not exceeded. It makes no sense auszureizen DVD.
If it does not, share the movie and play it on 2 DVD.
Antwort von sven1178:
Hello,
it worked, thank you
