Frage von Lotha_r:
Hello Visitor Forum
earlier, with Windows 2000 and AP 5.1c I could sit at a clip speed to 25%, and the slow motion was pretty fluent, because AP 5.1c used the option "fields, at speeds below 100% always join". Thus constructed AP 5.1c from 50 fields 50 frames, which then resulted in 25% play speed that each frame only 2x, and the repeated slow motion fluid remained.
And now in AP Pro 1.5.1 is repeated at 25% clip speed, each frame 4 times, join even though I have selected the option "fields forever". Have already been tested hours, in addition to the Matrox I bought an extra RT.X100 Canopus ACEDVio. But nothing will help. The problem would lie in the AP Pro 1.5.1. But where?
Am very grateful for any tip.
Lothar
Antwort von Wiro:
Hello,
under Halbbildoptionen imagine the following:
Calculation Options = Without
Changes in speed. . . . = Enabled
zum Bild Greeting Wiro
Antwort von Lotha_r:
Hello
Thanks for the tip. If until now, although the best result, however, due to the fading of the frames one at tightening moves. In sports photography it looks a little out of spirits after film. Is there any other possibility? Have the same scene with my old editing system set at 25%. No flickering, no jerking, no ghosting. That it would be possible in the latest AP Pro synonymous.
Gruss Lothar
