Frage von Omegaforces:
Hey guys,
I'm ready for a few days a new video, or would have done if you were not there this mysterious jerkiness. The video is in the AVCHD format and is ready cut and effektiert and everything and even fully rendered in Premiere and is synonymous everything is perfect. When I run the whole now than it jerky play mpg4 H264 s.manchen bodies (; strangely only s.einem later synonymous and then no discernible pattern). The tendency of the jerkiness is therefore more likely on long videos and then towards the end, I have noted, for other videos with similar length, in part, to the same thing. Also, there is no "ordinary jerky," as if the PC / Codec with the presentation hinterherkommt not, but my hardware is synonymous to good as new (; 3.4 ghz quad and 8gb of RAM) .. it is rather as if the picture would jump back and forth s.manchen bodies, yes, I can not describe synonymous.
Here are the Export Settings:
MainConcept H.264
PAL
1920x1080
25fps, progressive
High Profile
Level 5.1
VBR 2-pass
Target bit rate: 27.5 mbps
Maximum bit rate: 40 mbps
I do not now, next, I render the Rucklersequenzen without the rest of the video (; which is just under 10 minutes long) are the sequences as in the preview to see, so no jerkiness and no twitch. I've tried synonymous different export settings, because it apparently is not synonymous. I have to be low bit rate for example about 17 mbps, with no success (or perhaps even lower? O_o)
The source files are all synonymous error, the error must occur so the final playing out of the video out from Premiere.
I ask for help and thank you in advance:)
Antwort von RickyMartini:
The pre-and recoil of the picture is to me synonymous accommodated times. However, I have spent only interlaced. An update of PPro and the Media Encoder should help IMO.
Antwort von Debug:
Hey guys,
Here are the Export Settings:
MainConcept H.264
PAL
1920x1080
25fps, progressive
High Profile
Level 5.1
VBR 2-pass
Target bit rate: 27.5 mbps
Maximum bit rate: 40 mbps
You select the end of synonymous to export "... Use maximum Render Quality .." ? No idea if it could be because ... only time such an idea ..
Antwort von Omegaforces:
Hey, thanks for the replies.
I will rausrendern the video again today with maximum Render Quality and installed updates. Frankly I am not as confident as I try but sometimes I write here then ran dismissed;)
